Hangar 9 1/4-Scale J-3 Cub ARF - Manual (Page 32)

32
 .Step 9
Slide.the.fuel.tank.into.the.fuselage.with.the.stopper.facing.
toward.the.top.of.the.fuselage..Use.a.rubber.band.to.keep.
the.fuel.tank.from.moving.rearward.in.the.fuselage.
 .Step 10
Use.two.#2.x.1/2-inch.sheet.metal.screws.to.secure.the.
battery.cover.in.position.behind.the.fuel.tank.
The.ignition.battery.should.be.placed.
next.to.the.fuel.tank.behind.the.firewall..
This.is.to.keep.as.much.separtation.
between.the.ignition.and.the.RX.
The.battery.pack.should.be.installed.
before.installing.the.fuel.tank..The.model.
was.flown.with.the.battery.pack.placed.
here.when.using.the.Zenoh.20ei.
 .Step 11
Trim.the.cowling.as.necessary.to.clear.the.muffler,.
carburetor.and.head.of.the.engine..Secure.the.cowling.
using.four.4-40.x.1/2-inch.socket.head.screws,.four.
pieces.of.cowl.screw.tubing.and.four.#4.washers.
Engine Installation (Gas)