Brookfield DV-II+ Programmable Viscometer - Manual (Page 67)

Brookfield Engineering Labs., Inc. Page 67 Manual No. M/97-164-F1 102
Appendix I - DVE-50 Probe Clip
Probe Clip DVE-50 is supplied with all model DV-II+ Viscometers, DV-III Rheometers, and
Digital Temperature Indicators. It is used to attach the RTD temperature probe to the LV Guard
Leg (Part No. B-20Y) or 600 ml low form Griffin beaker. Figure H1 is a view of the Probe
Clip, showing the hole into which the RTD probe is inserted, and the slot which fits onto the LV
guard leg. When inserting the RTD probe into the Probe Clip, the upper part of the Clip is
compressed by squeezing the points shown in Figure H1. Note: All Viscometer/Rheometer
models — except LV — use the Probe Clip as shown in Figure H3.
Figure H2 shows the Probe Clip (with RTD temperature probe installed) mounted on the LV
guard leg.
Figure H3 shows the Probe Clip mounted in a 600 ml low form Griffin beaker. This mounting
may be used with LV, RV, HA and HB series instruments.
Note: The RTD probe must be parallel to the beaker wall so as not to interfere with the
viscosity measurement.
Figure H2 Figure H3
RTD Probe
Hole
Squeeze Here when
installing RTD
Temperature Probe
Figure H1
LV Guard Leg
Assembly B-20Y
Probe Clip
DVE-50 RTD Temperature
Probe
600 ml
500 ml
400
300
200
100
USA
No. 14000
600 ml Low Form
Griffin Beaker
DVE–50
Probe Clip
RTD Temperature Probe