Brookfield DV-II+ Programmable Viscometer - Manual (Page 19)

Brookfield Engineering Labs., Inc. Page 19 Manual No. M/97-164-F1 102
III. OPTIONS
III.1
TAB
OPTIONS Introduction to OPTIONS
The OPTIONS/TAB key provides access to the configuration (Setup) of the DV-II+ Viscometer as
well as special functions that can enhance the user's ability to make viscosity measurements.
The Options menu, shown in Table 1, gives a complete picture of the various configuration
choices and special functions.
Quick References to Options
Table 2
Options Menu
SETUP:
Temperature —
°
F or
°
C
Units — CGS or SI
* Speed Sets — Sequential, Interleave, Custom
Printer Port — Serial (RS232) or Parallel
Data Averaging — Display Only
* TIME TO STOP
* TIME TO TORQUE
SET PRINT TIME:
Set the Printing Time
PC PROG (ON/OFF):
Enables/Disables Communication of Serial (RS232) Port
* DOWNLOAD A PROGRAM:
Link to PC to Receive a B.E.V.I.S. Program
(B.E.V.I.S. = Brookfield Engineering Viscometer Instruction Set)
* RUN A PROGRAM:
Execute a B.E.V.I.S. Program
*Not available when motor is ON
Pressing OPTIONS/TAB places you into the Options menu at the last option selected. The following
keys are active and perform as follows:
UP ARROW - Scrolls up through menu or selects new value from
list.
DOWN ARROW - Scrolls down through menu or selects new value
from list.