Brookfield DV-II+ Programmable Viscometer - Manual (Page 22)

Brookfield Engineering Labs., Inc. Page 22 Manual No. M/97-164-F1102
L °F(FAHRENHEIT)
CGS UNITS
L SEQUENTIAL
PRINT SERIAL
L PRINT SERIAL
DATA AVERAGING
L °F(FAHRENHEIT)
CGS UNITS
L CGS UNITS
SEQUENTIAL
L °C(CENTIGRADE)
CGS UNITS
L °F(FAHRENHEIT)
SI UNITS
L CGS UNITS
INTERLEAVE
L SEQUENTIAL
PRINT PARALLEL
L CGS UNITS
CUSTOM SPEEDS
TAB
OPTIONS
Figure 25
III.2.1 Temperature Display
The DV-II+ viscometer can display temperature in either degrees Centigrade or degrees Fahrenheit.
On entry (assuming the viscometer is currently displaying
°
F) you will be presented with:
L °F(FAHRENHEIT)
CGS UNITS
Figure 26
A press of the OPTIONS/TAB key at this point will “toggle” between the two available temperature
scale options as shown in Figure 27:
L °F(FAHRENHEIT)
CGS UNITS
L °C(CENTIGRADE)
CGS UNITS
Figure 27
To select the temperature display mode, press the ENTER/AUTORANGE key. You automatically exit
the Setup menu with the viscometer displaying temperature in the selected scale. You must press the
ENTER/AUTORANGE key to select the flashing option.
III.2.2 Units of Measurement
Selecting units of measurement is identical to that for temperature described above. The screen
display shows: