Brookfield DV-II+ Programmable Viscometer - Manual (Page 33)

Brookfield Engineering Labs., Inc. Page 33 Manual No. M/97-164-F1 102
RUN PGM SLOT#1
PRESS ENTER
Figure 60
Using the UP/DOWN ARROW keys, select one of the four (4) stored programs. Press the ENTER/
AUTORANGE key. Any attempt to select a program slot that does not contain a program will result
in a double beep for each key press. When a valid program slot is selected, the screen in Figure 61
is displayed:
PRINT KEY = LIST
ENTER KEY = RUN
Figure 61
At this point, you may elect to print the B.E.V.I.S. program by pressing the PRINT key or start the
program immediately by pressing the ENTER/AUTORANGE key (remember: pressing the MOTOR ON/
OFF/ESCAPE key will stop the current operation and bring you back one menu level). You may elect
to print the program, to confirm the slot choice as correct or simply to have it available later when
reviewing data. If you elect to print the program, you will return to the screen of Figure 60 after the
program is finished printing. Pressing the
ENTER/AUTORANGE key exits the screen of Figure 60 and
the program will start running.
On program start, the screen could be any of the screens possible when running a B.E.V.I.S. program.
A typical screen might be:
USE SPINDLE 31
PRESS A KEY
Figure 62
where the operator is instructed to mount a spindle 31 and then press a key to continue. Or you might
see:
SET TEMP TO 100C
PRESS A KEY
Figure 63
followed by:
WAIT TEMP 100C
P1 S00/12 00:14
Figure 64
Here, the B.E.V.I.S. program is waiting for the temperature to reach one hundred (100)
°
C before it
continues to the next program step. Also displayed is the program number (P1), the step number
and the total program steps (S00/12) and the elapsed time since the program (or step) began (00:14).
While in this “wait state” you can press the
OPTIONS/TAB key to see the viscometer default screen
in Figure 65; the PGM will be flashing.