Aviom 6416dio - Manual (Page 82)

72 v
irtuAl
d
AtA
c
Ables
75Ω
TERMINATION
B A
Digital I/O Module
AES3 I/O CHANNELS 9–16 AES3 I/O CHANNELS 1–8
6416
dio
AC POWER
1 AMP
PIN 1 = GND
PIN 4 = 24VDC
IN
OUT
RS-232/422
FUSE: 250VAC-F4AL
BACKUP POWER
1 2 3 4 1 2 3 4
GPIO INPUT
UP = ISOLATED
DN = TTL
PORT SETUP 1–8 CTRL MASTER

232 / 422

10
12 RESERVED 9, 11
ON
WORD CLOCK
IN
75Ω
TERMINATION
OUT
DIGIDESIGN / TASCAM COMPATIBLE
YAMAHA COMPATIBLE
VIRTUAL DATA CABLE PORTS
The first eight switches on the DIP switch block are used to set the RS-
232/422 baud rate.
The RS‑232/422 port is also used for computer communication during
firmware updates and other Managed Mode applications.
The RS‑232/422 port on the 6416dio uses a 9‑pin DB9 connector and eight of
the twelve DIP switches in the DIP switch block (the remainder are used for
system functions).
RS-232/422 Configuration DIP Switches
RS‑232/422 communication is configured using the first eight switches in the
DIP switch block. Switches 1‑4 set the baud rate, and switches 5‑9 are used
to set data, parity, and stop bit options. Switches 9 and 10 are reserved for
system use.
Switch 12 is used to select either RS‑232 or RS‑422 communication.
Switch Function Off On
1 Baud Rate bit 3
See Baud Rate chart
2 Baud Rate bit 2
3 Baud Rate bit 1
4 Baud Rate bit 0
5 Data Bits 7 8
6 Parity Low/High No parity Parity
7 Parity Even/Odd Even Odd
8 Stop Bit 1 2
9 Reserved
10 Control Master
11 Reserved
12 RS‑232/422 select RS‑232 RS‑422
To set a DIP switch to the On position, push it upwards.