Aviom 6416dio User Manual
Page 74
64
F
irmwAre
u
PdAte
• Password protect is off.
The system
•
password value for the module being reset is
“1‑1‑1‑1.”
All Virtual Data Cables are deactivated.
•
The Control Master setting is hardware controlled and dependent upon the
rear‑panel DIP switch settings. These settings are not changed when factory
defaults are restored.
VDC configuration for GPIO type—Isolated or TTL—is not reset. VDC baud
rate, parity, and stop bit settings for RS‑232/422 communication are not
reset. These are hardware settings configured via the DIP switches in the
VDC section of the rear‑panel part of the interface.
Restoring factory defaults is a local function; only the module where the
function is engaged will be reset.