Aviom 6416dio - Manual (Page 73)

63 F
irmwAre
u
PdAte
and green channel meter LEDs will flash in sequence. When the firmware
update has been sent successfully, the module will reset and audio will be
restored.
When a module is being updated via A‑Net in an active network, the dot in
the A‑Net Slot display will be on, indicating that a network firmware update
is in progress.
When a module is waiting for an update to begin, you can exit the update
state by pressing the C
anCEl
button. If the update has not yet started, the
module will attempt to reset, returning it to normal operation.
P N
ote
: Do not press the C
anCEl
button or exit the Pro64 Update Tool
application while a firmware update is in progress.
Restore Factory Defaults
Function 16 restores the 6416dio module to its factory default settings.
To restore the factory default settings, press F
unCtion
followed by the
ChannEl
16 a
CtivE
button. The Enter/Cancel LED and the sixteen red channel level
LEDs will flash, indicating that this function will interrupt normal network
operation. Press E
ntEr
to continue and recall the factory default settings, or
press C
anCEl
to exit, leaving the current settings in place.
The Factory Default settings are:
A‑Net Input Slot is set to 1. •
A‑Net Output Slot is set to 1. •
Bank Select for the Input and Output sections is set to •
Channels 1‑8.
Auto Mode is selected.
•
• Manual Mode Transmit is set to Port A and Port B.
• Manual Mode Receive is set to Port A.
• Clock Source is set to Network.
The • Clock Master setting is de‑activated if the 6416dio
powers up without the Control Master DIP switch in the Off
position. It is activated if the Control Master DIP switch is in
the On position.
• Sample Rate is set to 48kHz.
All audio channels are muted and deactivated for • Auto,
Manual, and Managed Modes.
All
• stereo links are deactivated for Auto, Manual, and
Managed Modes.
Managed Mode is deactivated.
•
• Edit Lock is set to off.