Aviom 6416dio - Manual (Page 67)

57 A
dvANced
F
uNctioNs
If the network password has been entered incorrectly, the Edit Lock LED
flickers. Repeat the steps above with the correct password.
Press the C
anCEl
button to exit without locking the network.
The Pro64 network will be locked until the network password is provided.
The E
dit
l
oCk
button will light to indicate that the network is locked.
Password Unlock
When a Pro64 network is password protected, the four‑digit password code
is required to unlock it. The network can be unlocked only at the Control
Master.
To unlock the network:
Press the 1. F
unCtion
button on the Control Master module.
Press the 2.
ChannEl
9 a
CtivE
button followed by E
ntEr
.
All channel Active buttons will flash twice and the Enter/ 3.
Cancel LED will start to flash.
Enter the current four‑digit network password.
4.
Press 5. E
ntEr
to complete the operation.
The Signal Present LEDs sweep from right to left to confirm 6.
that the network is now unlocked.
If the network password has been entered incorrectly, the Edit Lock LED
flickers. Repeat the steps above with the correct password.
To exit the unlock request without unlocking the network, press C
anCEl
to
exit.
Set a New Password
Each Pro64 module can store a network password. However, the password
lock/unlock feature can only be used from the network Control Master.
Passwords can be changed only when the network is unlocked.
The password is a four‑digit number created using the numbered channel
activation buttons 1‑16 on the front panel. Passwords can include repeated
numbers (such as the default factory‑supplied password of 1‑1‑1‑1). When
creating a password, any string of numbers can be used, but note that only
the last four button presses are stored.
To set a new password:
Press 1. F
unCtion
and then the
ChannEl
10 a
CtivE
button.
Press 2. E
ntEr
.
Enter the current four‑digit network password. 3.
Press 4. E
ntEr
.