Panasonic NV-HS1000EC - Manual (Page 28)

1
ShowView Programming
Programming is now easier than ever; simply enter the
ShowView number provided in the programme schedule
column carried by newspapers and magazines.
ShowView numbers are numbers which are assigned to
each programme listed in the TV programme schedule
carried in newspapers and TV guides. When these
numbers are entered and TRANSMIT is pressed, the
numbers are converted into the actual programming and
sent to the VTR.
Preparation
• Insert a cassette tape with an intact erasure prevention
tab.
•Set the programme positions on both the VTR and remote
controller as shown on pages 12-15.
Operations Display Symbols
^ open the door of the remote controller.
.Vmt V ..'f-
re«
D OK
'
.OFF .
O Press SHOWVIEW.
vrni
HWMffil
rew
^ Enter a ShowView number.
^ txampie: uiiuiiie)
1/TH1
re«
A Press CONFIRM to check that the
^ number corresponds to the right
programme.
CONFIRM
O
su
Off
•To make any corrections, use buttons 0
~
0
-
Press TRANSMIT.
On Screen Display
; mei .
Po DOTE ON ' ■ ■ { W '
3 .is/to ; 1* *30 sr
K StWA. 1030 .trflO IP
U SU 10:00.. 1*00 SPi S 'lSflO ■ felS-i'-'Z*»”
2 mo ma »
■ sascr'-;* vOWBtt'::
Close the door of the remote controller.
Notes:
•To select the desired tape speed, press RECORDING
SP/LP in any of steps 3-4,
•To cancel the PDC/VPS function, press PDC/VPS in any
of steps 3-4.
•When the ShowView number is used for programming,
the recording time may be slightly longer than the actual
programme time.
• Repeat steps 2 to 4 if “Err” appears on the remote
controller.
•When programming two or more programmes, repeat
steps 2 to 5.
•The procedures for checking and cancelling whatever has
been programmed are the same as for remote control
programming.