Panasonic NV-HS1000EC - Manual (Page 14)

Setting Up the Remote
Controller for the ShowView
Programming
This remote controller uses specially designated numbers
called “guide numbers’’ to differentiate between the TV
stations. Before programming using the ShowView
numbers, you must enter the guide numbers of the TV
stations to be viewed and the programme positions at which
those TV stations are received on the VTR into the remote
controller. Have a newspaper or magazine at hand which
lists the TV station guide numbers and ShowView numbers.
Note:
To receive satellite stations, the satellite receiver must be
connected to the VTR and programme position must be set
depending on the type of the connection made.
A1: When the satellite receiver is connected to the AV1
socket
A2: When the satellite receiver is connected to the AV2
socket
A3; When the satellite receiver is connected to the
Audio/Video input sockets (AV3)
•When the satellite receiver is connected by means of the
RF coaxiai cable, set to a free programme position
between 1 and 99,
Preparation
Set the clock of the remote controller first.
For Example:
TV Statl
progranmte
Poeitloir
ARD 001 1
ZDF 002 2
RTL 004 4
SAT1 005 3
Operations Display Symbols
Open the door of the remote controller.
VTR1
(tews D ON OFF
Keep CLOCK/PRESET pressed for
more than 2 seconds and then press it
again.
o
CLOCK/PRESET
mr.
■ n n 1
UU t
3 Select the guide number (001-255).
OFF
+
o
VTB1 KimLi
n n 1
u u»
A Select the programme position
^ (1-99, At-A3).
. 0 n 1
■r uu 1
•To set the other TV stations, repeat steps 3 and 4.
Press CLOCK/PRESET twice.
O
CLOCK/PRESET
¡a«® c» tiff ■
Close the door of the remote controller.