Configuration roadmap, Data preparation, Configuration procedure – Panasonic NN46240-502 User Manual
Page 70
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration - LAN Access and MAN Access
4 VLAN configuration
Figure 4-6 Networking diagram of configuring VLANs to communicate through a router
GE2/0/0.1:
10.110.4.3/24
GE2/0/0.2: 10.110.3.3/24
GE1/0/0.1: 10.110.6.3/24
1GE1/0/0.2: 10.110.5.3/24
9
VLAN30
10.ÏTÔ.4.0724
SwitchA
m
VLAN40
10T1073''0/24
9 t|
VLAN10
10.110.6.0/24
SwitchB
10.110.5.0/24
Configuration roadmap
The configuration roadmap is as follows:
• Configure the encapsulation mode on all the Ethernet interfaces to 802.1Q.
• Configure the IDs of the VLANs to which each Ethernet interface belongs.
• Configure the IP address of each Ethernet interface.
Data preparation
To complete the configuration, you need the following data.
• The VLAN IDs of the Ethernet subinterfaces GE 1/0/0.1 and GE 1/0/0.2 are 10 and 20
respectively.
• The VLAN IDs of the Ethernet subinterfaces GE 2/0/0.1 and GE 2/0/0.2 are 30 and 40
respectively.
• The IP addresses of GE 1/0/0.1 and GE 1/0/0.2 are 10.110.6.3 and 10.110.5.3
respectively.
• The IP addresses of GE 1/0/0.1 and GE 1/0/0.2 are 10.110.4.3 and 10.110.3.3
respectively.
Configuration procedure
Step 1 Configure the interface connected with Switch B on the router.
• Create and configure the subinterface GE 1/0/0.1.
[Router] interface gigabitethernet 1/0/0.1
[Router-GigabitEthernet1/0/0.1] vlan-type dot1q 10
[Router-GigabitEthernet1/0/0.1] ip address 10.110.6.3 255.255.255.0
[Router-GigabitEthernet1/0/0.1] quit
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
4-11