Panasonic NN46240-502 - Manual (Page 51)

3 Ethernet interface configuration
Nortel Secure Router 8000 Series
Configuration - LAN Access and MAN Access
3.3 Maintaining Ethernet interfaces
A
Debugging affects system performance. After you debug the Ethernet interface, run the undo
debugging all command to disable debugging.
When a fault occurs on an Ethernet interface, run the following debugging commands in the
user view to locate the fault.
For information about displaying debugging information, see Nortel Secure Router 8000
Series Configuration - System Management (NN46240-601).
Action Command
Enable debugging of the
Ethernet interface.
debugging ethernet packet [ arp | error | ip | ipv6 | isis |
l2vpn | mpls | pppoe ] [ verbose ] [ interface interface-type
interface-number ]
Enable debugging of the
Ethernet interface based on
the MAC address.
debugging ethernet packet mac { dest_mac dest-mac |
src_mac src mac }
3.4 Configuration examples
This section provides an example procedure for configuring an Ethernet interface.
3.4.1 Example of configuring an Ethernet interface
Networking requirements
As shown in Figure 3-1, the Ethernet interfaces of Router A, Router B, and Router C are
connected to the IP network 202.38.165.0/24.
3-8 Nortel Networks Inc. Issue 5.3 (30 March 2009)