5 enabling the interface, 5 enabling the interface -6, Enabling the interface – Panasonic NN46240-502 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

1 LAN access overview

Nortel Secure Router 8000 Series

Configuration - LAN Access and MAN Access

This command configures the global interval of flow statistics.

CQ NOTE

The interval of traffic statistics configured by this command can be applied to each physical interface.

—End

Configuring the interface interval of flow statistics

Do as follows on the routers:

Step 1 Run:

system-view

The system view appears.

Step 2 Run:

interface interface-type interface-number

The specified interface view appears.

Step 3 Run:

interface traffic sampling-time time

This command configures the interface interval of flow statistics.

NOTE

• When the global interval of flow statistics and the interface interval of flow statistics are configured

at the same time, the interface selects the interface interval of flow statistics first.

• The physical interfaces support the configuration of the interval of flow statistics. For logical

interfaces, the interval of flow statistics uses the default system value and cannot be changed through

configuration.

—End

1.2.5 Enabling the interface

After you configure the interface, enable the interface and note the following:

• When a physical interface is idle and not connected to cables, shut down the interface to

protect it from interference.

• After the interface configuration is complete, run the restart command, or run the

shutdown and undo shutdown commands consecutively, to validate the configuration.

Running the restart command is the same as running the shutdown and the undo

shutdown commands consecutively.

NOTE

When subinterfaces exist, if you run the shutdown command and the undo shutdown command on the

main interface in succession, the two commands must be used at an interval of at least 15 seconds.

When the interface status or the protocol status changes, the output automatically appears, as

shown in the following example:

%Jan 22 17:24:54 2007 Nortel IFNET/2/UPDOWN:Line protocol on the interface Ethe

rnet1/1/1 turns into UP state

1-6

Nortel Networks Inc.

Issue 5.3 (30 March 2009)