Panasonic NN46240-502 User Manual
Configuration guide - lan access and man access, N0rtel
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Table of contents
Document Outline
- N0RTEL
- 1
- LAN access overview
- Contents
- MAC address table configuration
- 2.2.1 Establishing the configuration task
- 2.2.2 Changing MAC address entries
- 2.2.3 Setting the aging time of a MAC address table
- 2.2.4 Checking the configuration
- 2.3.1 Establishing the configuration task
- 2.3.2 Configuring MAC address learning limit rules based on a VSI
- 2.3.3 Checking the configuration
- 2.4.1 Example of configuring a MAC address table
- 2.4.2 Example of configuring the MAC address learning limit based on a VSI
- Contents
- Figures
- Ethernet interface configuration
- 3.1.1 Introduction to Ethernet interfaces
- 3.1.2 Classification of Ethernet interfaces
- 3.2.1 Establishing the configuration task
- 3.2.2 Assigning an IP address to an Ethernet interface
- 3.2.3 Configuring the MTU of an Ethernet interface
- 3.2.4 Configuring the working mode of an Ethernet electrical interface
- 3.2.5 Configuring the speed of an Ethernet electrical interface
- 3.2.6 Configuring the loopback function of an Ethernet interface
- 3.2.7 Configuring the preamble length for packets sent by the Ethernet interface
- 3.2.8 Checking the configuration
- 3.4.1 Example of configuring an Ethernet interface
- 3.5.3 Ethernet interfaces discard packets
- Contents
- Figures
- 4
- VLAN configuration
- OQ NOTE
- 4.1.3 Communication between VLANs
- 4.2.1 Establishing the configuration task
- 4.2.2 Encapsulating the subinterface with dotlq
- 4.2.3 Configuring an IP address for the subinterface
- 4.2.4 Checking the configuration
- 4.3.1 Clearing VLAN packet statistics
- 4.3.2 Debugging the VLAN
- 4.4.1 Example of configuring different VLANs to communicate through routers
- 4.4.2 Example of configuring VLANs to communicate with non-VLANs through routers
- Contents
- Contents
- Index
- VLAN configuration