1 clearing vlan packet statistics, 2 debugging the vlan, 1 clearing vlan packet statistics -9 – Panasonic NN46240-502 User Manual
Page 68: 2 debugging the vlan -9, 3 maintaining the vlan
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration - LAN Access and MAN Access
4 VLAN configuration
Run the display vlan statistics command. If the number of received and sent packets or bytes
and the number of received and sent error packets are displayed, the configuration is
successful. For example:
VLAN packet statistics:
0 Packets received, 0 bytes
0 Packets transmitted, 0 bytes
0 Received error ,0 Transmitted error
VLAN packet statistics:
0 Packets received, 0 bytes
0 Packets transmitted, 0 bytes
4.3 Maintaining the VLAN
This section describes the following topics:
• Clearing VLAN packet statistics
4.3.1 Clearing VLAN packet statistics
A
After you clear VLAN packet statistics, you cannot restore them. Confirm that you want to
complete this action before you use the command.
To clear VLAN packet statistics, run the following reset commands in the user view.
Action
Command
Clear packet statistics for a specified
VLAN.
reset vlan statistics [ vid ] vlan-id
Clear packet statistics for a specified
subinterface.
reset vlan statistics interface interface-type
interface-numher.suhinterface-numher
4.3.2 Debugging the VLAN
A
Debugging a^ects system performance. After you debug the VLAN, run the undo debugging
all command to disable debugging.
When a fault occurs on the VLAN, run the following debugging command in the user view to
locate the fault.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
4-9