5 troubleshooting, Configuration files, Fault description – Panasonic NN46240-502 User Manual
Page 38: Fault analysis, Troubleshooting procedure, Check whether the configuration is valid, Check the mac address learning states
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration - LAN Access and MAN Access
2 MAC address table configuration
[Nortel] vsi vsi1
[Nortel-vsi-vsi1] mac-limit maximum 100 rate 50
[Nortel-vsi-vsi1] quit
# Check whether the configuration is valid.
[Nortel] display mac-limit
MAC Limit is enabled
Total MAC Limit rule count : 1
VLAN/VSI Maximum Rate(ms) Action Alarm
vsi1
100
50
discard enable
# Check the MAC address learning states.
[Nortel] display mac-limit vsi vsi1
Vsi1 MAC limit:
Maximum MAC count 100, rate 50(ms)
Action: discard, Alarm: enable
Configuration files
#
sysname Nortel
#
vsi vsi1
#
vsi vsi1
mac-limit maximum 100 rate 50
#
return
2.5 Troubleshooting
Fault description
The mac-address command fails to add a MAC address entry.
Fault analysis
The possible causes are as follows:
• The MAC address is a multicast address.
• The configured nondynamic entries exceed 1024.
Troubleshooting procedure
Step 1 Check whether the configured MAC address is a multicast address. Multicast address entries
are not allowed in a MAC address table.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
2-9