Panasonic NN46240-502 - Manual (Page 48)

Nortel Secure Router 8000 Series
Configuration - LAN Access and MAN Access 3 Ethernet interface configuration
Step 3 Run:
ipv6 mtu mtu
This command configures the IPv6 MTU of the Ethernet interface.
—End
3.2.4 Configuring the working mode of an Ethernet electrical
interface
Do as follows on each router:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface { ethernet | gigabitethernet } interface-number
The Ethernet interface view appears.
Step 3 Run:
duplex { full | half | negotiation }
This command configures the working mode of the interface.
Où NOTE
• Ethernet optical interfaces can work only in full-duplex mode.
• When connected to a hub, the Ethernet electrical interfaces of a router must work in half-duplex
mode. When connected to a LAN switch, the interfaces can work in either full-duplex mode or
half-duplex mode, but only if the mode is consistent with that on the peer device.
—End
3.2.5 Configuring the speed of an Ethernet electrical interface
Do as follows on each router:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface { ethernet | gigabitethernet } interface-number
The interface view appears.
Step 3 Perform one of the following steps based on the type of interface (FE or GE):
• Run:
speed { 10 | 100 | negotiation }
Issue 5.3 (30 March 2009) Nortel Networks Inc. 3-5