Panasonic NN46240-502 - Manual (Page 24)

Nortel Secure Router 8000 Series
Configuration - LAN Access and MAN Access 1 LAN access overview
1.2.2 Entering the interface view
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface interface-type interface-number
The interface view appears.
For an overview of interface numbering, see Table 1-3.
For detailed information about interface numbering, see Nortel Secure Router 8000 Series -
Installation (NN46240-300 or NN46240-301).
—End
1.2.3 Configuring the interface description
Before you configure an interface, you need to understand the networking requirements and
know the following information:
• how the physical interface is connected
• the working mode and parameters that are required for the interface
• the negotiated link layer protocol and working parameters between the interface and the
peer interface
• the network protocol address supported by the interface
• the static route or dynamic routing protocol on the interface
• parameters for packet filtering and Network Address Translation (NAT) if a firewall is
set up on the interface
03 NOTE
The Secure Router 8000 Series supports the description interface-description command in the interface
view, which configures the interface description. The description identifies the interface function and is
useful for interface maintenance.
1.2.4 Configuring the interval of flow statistics
Configuring the global interval of flow statistics
Do as follows on the routers:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface traffic sampling-time time global
Issue 5.3 (30 March 2009) Nortel Networks Inc. 1-5