2 assigning an ip address to an ethernet interface, Preconfiguration tasks, Data preparation – Panasonic NN46240-502 User Manual
Page 46: Configuration procedures
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Nortel Secure Router 8000 Series
Configuration - LAN Access and MAN Access
3 Ethernet interface configuration
Preconfiguration tasks
None
Data preparation
To configure an Ethernet interface, you need the following data.
No.
Data
1
Interface number
2
IP address and mask of the Ethernet interface
3
Maximum Transmission Unit (MTU) of the Ethernet interface
Configuration procedures
No.
Procedure
1
Assigning an IP address to an Ethernet interface
2
Configuring the MTU of an Ethernet interface (optional)
3
Configuring the working mode of an Ethernet electrical interface (optional)
4
Configuring the speed of an Ethernet electrical interface(optional)
5
Configuring the loopback function of an Ethernet interface (optional)
6
Configuring the preamble length for packets sent by the Ethernet interface
7
3.2.2 Assigning an IP address to an Ethernet interface
Do as follows on each router:
Step 1 Run:
system-view
The system view appears.
Step 2 Run:
interface { ethernet | gigabitethernet }
interface-number
The Ethernet interface view appears.
Step 3 Run:
ip address
ip-address { mask
|
mask-length }
[
sub ]
This command configures the IP address of the Ethernet interface.
Issue 5.3 (30 March 2009)
Nortel Networks Inc.
3-3