Multinetting – Panasonic 7 User Manual

Page 97

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Chapter 5 Configuring the system 97

MAC Pause (Ethernet packet flow control) section enables the Nortel VPN

Router to automatically adjust and control the flow of incoming and/or

outgoing packets from any standard speed LAN device.

Check to enable MAC Pause (Frame-based flow control) on the selected

interface port.

When enabled, specify the appropriate Pause parameters to be set in the
hardware.

Specify a value for MAC Pause Ticks.

Select a value from the Free Receive FIFO Threshold list. The default is 0.

Select Enabled or Disabled for the 802.1Q VLAN setting. Enabling 802.1Q

VLAN requires that you set this option to Enabled and then click OK. This

takes you back to the System > LAN window.

Enter an identification number for a VLAN ID in the range 1 - 4094,
inclusive. This is the VLAN identifier for the interface VLAN. The default

value is 1.

Select Accept Untagged to accept Ingress inbound frames untagged or

Discard Untagged to drop them.

10 Select Tagged too tag Egress (outbound) frames. Untagged is default.

11 Click Configure Subinterfaces to configure and to view existing VLAN

subinterfaces on the selected interface.

12 Click Subinterface Statistics to view current statistical information about the

selected VLAN subinterface.

Multinetting

You configure multinetting on the LAN port using either the System > LAN

window or on the CLI. Multinetting requires a primary interface that must be

present before adding secondary addresses. However, in a configuration where
both primary and secondary addresses are defined, changing the primary address
is not possible.

All secondary addresses must be deleted before the primary address can be

changed.

Nortel VPN Router Configuration — Basic Features