Accessing acl through the gui, Configuring the serial interface – Panasonic 7 User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/653616/45/background.png)
Chapter 2 Getting started 45
To set an ACL for TELNET, enter the following NNCLI command:
CES(config)
#telnet access-list
To remove an ACL for TELNET, enter the following command:
CES(config)
#no telnet access-list
Accessing ACL through the GUI:
To access ACLs from the GUI:
1
Select Services > Available. The Allowed Services window appears.
2
Select one of the predefined ACLs.
3
Click OK.
Configuring the serial interface
The Serial Interface allows you to configure the IP address and subnet mask so
that you can then use a Web browser for management.
Your terminal emulator must use the following communications parameters:
9600 baud
8 data bits
1 stop bit
No parity
No flow control
The Serial Interface configuration procedure is typically only necessary in a
system recovery situation.
1
Connect the serial cable (supplied with your Nortel VPN Router) from the
Nortel VPN Router serial port to a terminal or a communications port of a PC.
2
Power on the terminal or PC.
Nortel VPN Router Configuration — Basic Features