Cable the vpn router and turn the power on – Panasonic 7 User Manual
Page 68
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
68 Chapter 3 Setting up the Nortel VPN Router 1010, 1050, and 1100
Power cord
AC to DC external power supply
Molded serial cable RJ-45 to DB9
Ethernet crossover cable (Nortel VPN Router 1010 only)
Nortel VPN Router CD (Note: the documentation on this CD is for reference
only)
Cable the VPN Router and turn the power on
To set up your Nortel VPN Router 1010, 1050, or 1100:
1 Connect a PC to the LAN 0 (private) port located on the front panel of the
VPN Router.
•
To connect a PC directly to the Nortel VPN Router 1010, use the Ethernet
crossover cable that was shipped with it. To connect more than one PC to
the Nortel VPN Router 1010, connect an Ethernet switch or hub to the
LAN 0 port and then connect the PCs to the switch or hub.
•
To connect PCs and other devices to the Nortel VPN Router 1050 or
1100, use standard Ethernet cables to connect the devices to the LAN 0
ports (labeled A-D).
2
If you have a Nortel VPN Router 1100 that has one or two optional interface
cards, connect the appropriate cables to the ports on the interface cards.
3
Using a standard Ethernet cable (not included with the VPN Router), connect
your cable or DSL modem to the LAN 1 (public) port located on the front
panel of the VPN Router.
4
Plug the power cord into the AC receptacle on the external power supply
shipped with the VPN Router.
5
Plug the power cord into the AC power outlet.
©
Caution: Protect the Nortel VPN Router 1010, 1050, or 1100 by
plugging it into a surge suppressor.
6
Plug the external power supply into the port labeled “DC Input” on the back
of the VPN Router.
NN46110-500