Deployment procedure – Panasonic 7 User Manual
Page 65
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Deployment procedure
The following sequence of events illustrates the deployment procedure.
•
Factory configured Nortel VPN Router 1010, 1050, and 1100 boxes are
shipped directly to the end customer. A provisioning worksheet is either sent
or faxed from the network operations center separately from the device.
•
The end user unpacks and connects the Nortel VPN Router to the network
using the readme included with the Nortel VPN Routerdevice. The Nortel
VPN Router is deployed between the internet access device (cable or DSL
modem) and the local network (Ethernet segment).
•
The end user restarts the PC to request a new IP address from the branch
office DHCP server (not all operating systems require rebooting).
•
The end user opens the Web browser and types , then clicks
on Manage Switch and enters admin and setup as the username and
password.
•
The BOQS displays one window to collect the IP and VPN configuration
parameters. The end user enters the required parameters using the worksheet
prepared by the NOC.
•
The BOQS configures a tunnel from the branch office Nortel VPN Router to a
Nortel VPN Router located at the central office and a management connection
(responder control tunnel) to enable further configuration from the NOC. The
NOC can take over configuring the box once the connection is established and
additional configuration is required.
Chapter 3 Setting up the Nortel VPN Router 1010, 1050, and 1100 65
Nortel VPN Router Configuration — Basic Features