Asynchronous data over tcp – Panasonic 7 User Manual
Page 105
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 5 Configuring the system 105
Asynchronous data over TCP
Asynchronous data over TCP (AOT) is a protocol that enables transport of
asynchronous data packets over a TCP/IP network. A TCP packet is de-capsulated
and the data is then forward to the synchronous driver to the asynchronous device
or host.
The Asynchronous protocol is used for communication of an alarm device with an
alarm host on a slow speed serial line. Unlike synchronous transmission,
asynchronous transmission does not use clocking signals to time the data
transmission. Instead, asynchronous transmission uses start and stop bits to
control the transmission. AOT is either a connection initiator or a listener, but it
cannot be both. The selection of service is through AOT configuration. Only a
single TCP connection is supported.
To enable asynchronous data over TCP/IP through the GUI:
1
Go to Services > AoT. The default is disabled.
Figure 16
Asynchronous data over TCP
2
Check to enable asynchronous over TCP/IP communications. The default is
disabled.
Nortel VPN Router Configuration — Basic Features