Adding a group, Adding a tunnel – Panasonic 7 User Manual

Page 130

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

130 Chapters Configuring branch office tunnels

Adding a group

To create a new group:

Select Profiles > Branch Office.

In Groups section, click Add. The Add Group window appears.

Enter a name and then select select the parent group whose attributes the new

group inherits; for example, /Base. The group name can be a maximum of 64
characters (spaces are permitted). The new group inherits the attributes (for
example, Access Hours) of its parent group, which are then used by the

branch office connection. Click OK. The Branch Office window returns.

You can also click Search All Groups to use a connection name or partial
connection name to locate and display all matching groups. You can then
configure the specific group or groups that you want.

Enter the name your want to search for in the Search Criteria window and

click on Search. The Search All Groups Results window appears, listing any
groups that match all or part of the specified connection name.

You can select a Group and then use the Configure button to review or

modify the group’s attributes.

Adding a tunnel

To add a tunnel connection:

1 On the Profiles >Branch Office window, in the Connections section, click

on Add. The Add Connection window appears.

Enter the Connection name (up to 128 characters).

If this is a Control Tunnel, select Enabled.

For Tunnel Type, select FFTP, IPSec, or LT2P.

For Connection Type, select Peer to Peer, Responder or Initiator.

Click OK. The Connection Configuration window appears. Continue to step
2 in “Configuring a tunnel connection” on page 131.

NN46110-500