Yamaha RX-V663 - Manual (Page 99)

start pairing START PAIRING
Use this feature to start pairing the connected Yamaha
Bluetooth adapter (such as YBA-10, sold separately) with
your Bluetooth component. For details about the pairing,
refer to “Pairing the Bluetooth^M adapter and your
Bluetooth^M component” on page 70.
To ensure security, a time limit of 8 minutes is set for
the pairing operation. You are recommended to read
and fully understand all the instructions before starting.
1 Press (D ENTER to start pairing.
The connected Bluetooth adapter starts searching
Bluetooth components. “Searching...” appears in the
video monitor.
2 Check that the Bluetooth component detects
the Bluetooth adapter.
If the Bluetooth component the Bluetooth adapter,
“YBA-10 YAMAHA” (example) appears in the
Bluetooth device list.
3 Select the Bluetooth adapter in the Bluetooth
device list and then enter the pass key
“0000” on the Bluetooth component.
Once this unit completes the pairing successfully,
“Pairing completed” appears.
infill
To cancel the pairing, press (D RETURN to exit from
“START PAIRING”.
4 Press (DRETURN to exit from “START
PAIRING”.
Notes
• If the connected Bluetooth adapter cannot find any Bluetooth
components, “Not found” appears.
• If a Bluetooth adapter is not connected to this unit, “No
Bluetooth Adapter” appears.
Multi-channel input BGV GGU
Use this feature to select the video source played in the
background of the sources input at the MULTI CH INPUT
jacks.
MULTI CH_____________
INPUT RENAME
UOL. TRIM.... 0.0dB
^ EGU...........LAST
INPUT CH....... 6CH
[ j I l ]/[ t ]
; IJp/Down
CENTER]: Select
Customizing this unit (MANUAL SETUP) \
^ ' j
LAST
Automatically selects the last selected video
source as the background video source.
DVD, DTV/
CBL, DVR,
VCR, V-AUX
Selects the corresponding input source as the
background video source.
OFF Does not play the video source in the
background.
Input Channels INPUT CH
Use this setting to select the number of channels input
from an external decoder (see page 25).
Choices: 6CH, 8CH
M> MULTI CH_____________
INPUT RENAME
UOL. TRIM.... 0.0dB
BGU........... LAST
INPUT CH....... bCH
[A]/[T]; U p .'■Down
CENTER]: Select
If the connected component outputs discrete
6-channel audio signals.
Select “6CH”.
If the connected component outputs discrete
8-channel audio signals.
Select “8CH”. Also set “FRONT” (see below) to the
analog audio jacks at which the front left and right
channel signals output from the connected component
are input.
Front left and right channels input jack FRONT
If you selected “8CH” in “INPUT CH”, you can select the
analog audio jacks at which the front left and right channel
signals output from the connected external decoder is
input.
Choices: CD, MD/CD-R, DVD, DTV/CBL, DVR, VCR,
V-AUX
' M> MULTI CH
INPUT RENAME
UOL. TRIM.... el.0dB
BGU............ LAST
INPUT CH...... ■ BCH
FRONT..........
[A]/[T]; IJp.'-Down
CENTER]: Select
Not0
“FRONT” parameter appears only when you set “INPUT CH” to
“8CH”.
95
En