Yamaha RX-V663 - Manual (Page 38)

Optimizing the speaker setting for your listening room (YPAO)
Press
®V
to select “START” and then press
©ENTER to start the setup procedure.
The following message appears in the OSD.
When this unit starts the automatic setup procedure,
loud test tones are output at the speakers.
For more accurate measurements, keep quiet and
move to the wall where speakers are not around. We
recommend that you leave the listening room during
the automatic setup procedure.
NOTICE
Loud test tones are
output.
Please keep =iuiet
or leaue the roon.
Press CENTER]
Once you perform the next operation, this unit starts
the automatic setup procedure.
8 Press ® ENTER to start the automatic setup
procedure.
The following screen appears in the OSD and setup
procedure starts in 10 seconds.
OLITO SETUP
Measurement Start
in 9 seconds
••iiiimmiiiiiiiiiiiiiiiiiimmiiii
[RETURN]:Cancel
Loud test tones are output from each speaker during
the auto setup procedure. Once all items are set, the
“RESULT” display appears in the OSD.
Notes
• During the automatic setup procedure, do not perform any
operation on this unit.
• We recommend that you get out of the room while this unit
is in the auto setup procedure. It takes approximately 3
minutes for this unit to complete the auto setup procedure.
Press ® A to cancel the automatic setup procedure.
9
Make sure that the following screen appears
and then press (D ENTER to display the
result screen.
flUTO SETUP
Measurement Complete
Press CENTER]
ftUTO SETUP
RESULT
SP : 3/4/0.1
DIST: 14.0/17.0ft
LUL : -9.0/+6.5dB
>SET CANCEL
CA]/CT]:Up/Down
CENTER]:Enter
The results displayed under “RESULT” are as
follows:
Number of speakers SP
Displays the number of speakers connected to this
unit in the following order:
Front/Back/Subwoofer
Speaker distance DI ST
Displays the speaker distance from the listening
position in the following order:
Closest speaker distance/Farthest speaker distance
Speaker level LUL
Displays the speaker output level in the following
order:
Lowest speaker output level/Highest speaker output
level
NoiSB
• The signal output at the SUBWOOFER PRE OUT 2 jack
is the same as the one output at the SUBWOOFER PRE
OUT 1 jack. Therefore, even if you connect two
subwoofers, the number of the connected subwoofer is
indicated as “0.1”.
• If “E-10:INTERNAL ERROR” appears during the testing
procedure, restart from step 4.
• If you selected other than “AUTO” in step 5, no test tones
are output.
• If an error occurs during the “AUTO SETUP” procedure,
the setup procedure is canceled and an error screen
appears. For details, see “If an error screen appears” on
page 36.
• When this unit detects potential problems during the
“AUTO SETUP” procedure, “WARNING” and the
number of warning messages appears in the above of
“RESULT” (see page 36).
• Depending on the listening environment, “SWFR
PHASEiREV” appears during the automatic procedure
and “SUBWOOFER PHASE” in “SOUND MENU” (see
page 87) is automatically set to “REVERSE”.
34 En