All channel search mode, Preset search mode, Category search mode – Yamaha RX-V663 User Manual
Page 63: Direct number access mode
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
XM Satellite Radio tuning
Before performing the following operations, press
(3)XM.
All Channel Search mode
1
Press ©SEARCH MODE (or @SRCH
MODE) repeatedly to select “ALL CH
SEARCH”.
2
Press ©PRESET/TUNING/CH
® PRESET/CH
A / V)
repeatedly to search
for a channel within all channels.
■ Preset Search mode
Prior to selecting a preset channel in the Preset Search
mode, you must preset XM Satellite Radio channels. For
details, see “Setting the XM Satellite Radio preset
channels” on page 60.
\i/
2(f>l
The initial factory setting of all preset channels (A1 to E8) is “001
Preview”.
1
Press ©SEARCH MODE (or (^SRCH
MODE) repeatedly to select “PRESET
SEARCH”.
• You can search for a channel quickly by pressing and holding
©PRESET/TUNING/CH
©PRESET/CH
A / V).
• To display the XM Radio ID number displayed in the front
panel display, select channel “0”.
■ Category Search mode
1
Press ©SEARCH MODE (or igiSRCH
MODE) repeatedly to select “CAT SEARCH”.
2
Press ©CATEGORY (or
®
A-E/CAT. <1
/
1>)
repeatedly to change the channel category.
3
Press ©PRESET/TUNING/CH
<1 / [>
(or
©PRESET/CH
A / V)
repeatedly to search
for a channel within the selected channel
category.
You can search for a channel quickly by pressing and holding
©PRESET/TUNING/CH
<1 /1> (or
©PRESET/CH
A / V)
2
Press ©CATEGORY (or ©A-E/CAT. <1 /1>)
repeatedly to change the preset channel
group (A to E).
3
Press ©PRESET/TUNING/CH <1 /1> (or
©PRESET/CH
A / V)
repeatedly to change
the preset channel number (1 to 8).
You can also select the preset channel number directly by
pressing the numeric buttons (1 to 8) (®).
■ Direct number access mode
Press i^SRCH MODE on the remote control
repeatedly to select “ALL CH SEARCH” or
“CAT SEARCH”.
Press the numeric buttons
(@)
to enter the
desired three-digit channel number.
For example, to enter the number 123, press the
numeric buttons (®) as shown below.
• To enter a one-digit or two-digit channel number, press the
numeric buttons (®) on the remote control and then press
®ENT
to confirm the input number.
• Instead of pressing ®
ENT
to tune into the channel
immediately, you can wait a few seconds until this unit confirms
the entered channel number.
• Pressing a button other than the numeric buttons (®) or @
ENT
cancels the Direct Number Access mode procedure.
59
En