Yamaha RX-V663 - Manual (Page 10)

Quick start guide
Step 1: Set up your speakers
Place your speakers in the room and connect them to this
unit.
PRE OUT SUBWOOFER 1 jack
; -
ì ;'
iiiiiiìilBliiillll
•• w . i. .-.C
V,- ,w,^.-f>,
ididBI
'
^
'
§{§ij(gjif)|@(|)(|)|(|)(|).
@(i)@)@)|@@@|@)[i!
Speaker terminals
1 Place your speakers and subwoofer in the
room.
2
Connect speaker cables to each speaker.
Be sure to connect the “+” (red) and (black) properly.
Cables are colored or shaped differently, perhaps with a
stripe, groove or ridge. Connect the striped (grooved, etc.)
cable to the “+” (red) terminals of this unit and your speaker.
Connect the plain cable to the (black) terminals.
3
Connect each speaker cable to the
corresponding speaker terminal of this unit.
© Make sure that this unit and the subwoofer are
unplugged from the AC wall outlets.
®
Twist the exposed wires of the speaker cables
together to prevent short circuits.
®
Do not let the bare speaker wires touch each
other.
0 Do not let the bare speaker wires touch any
metal part of this unit.
Be sure to connect the left channel (L), right channel
(R), (red) and (black) properly.
Front speakers and center speaker
To the front right
speaker
To the center speaker
To the front left
speaker
Surround and surround back speakers
■ J L
To the surround
right speaker
To the surround
back left speaker
To the surround To the surround
left speaker back right speaker
4
Connect the subwoofer cable to the
SUBWOOFER PRE OUT 1 jack of this unit
and the input jack of the subwoofer.
Subwoofer AV receiver
You can also connect another subwoofer to the SUBWOOFER
PRE OUT 2 jack.
6
En