If “warning” appears, Not0, If an error screen appears – Yamaha RX-V663 User Manual

Page 40: The top “set menu” screen appears in the osd, Choices

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Optimizing the speaker setting for your listening room (YPAO)

Press (DENTER to confirm your selection.

The top “SET MENU” screen appears in the OSD.

SET MENU

^ -fiUTO SETUP

■hflNUflL SETUP

■ SIGNAL INFO

C A ] / [ T ] : U p / D o w n

[ENTER]:Enter

16 Press (iiMENU to exit from “SET MENU”.

If you change speakers, speaker positions, or the layout of your

listening environment, run “AUTO SETUP” again to recalibrate

your system.

■ If “WARNING” appears

When this unit detects potential problems during the

“AUTO SETUP” procedure, “WARNING” appears in the

top result display. Check the warning messages to correct

your speaker settings.

Not

Warnings differ from errors in that warnings do not cancel the

“AUTO SETUP” procedure.

Make sure the pointer is pointing at

“WARNING” and then press (DENTERto
display the detailed information about the
warning.

The number on the right of “WARNING” indicates

the number of warning messages.

If an error screen appears

Press d)/^ / V / <3 /1> to select “RETRY” or
“EXIT” and then press ©ENTER.

The following display is an example when “E-9:USER

CANCEL” appears in the OSD.

AUTO SETUP

^ WARNINGS.3>

RESULT

SP :

3/4/0.1

DIST: 14.0/17.0ft

LUL : -9.0/+6.5dB

>SET CANCEL

[A]/[T]:lJp/Down

[ENTER]:Detail

ERROR

^ E-9:USER CANCEL

Don’t operate

any function

Press

® <3 /1>

repeatedly to toggle between

the warning displays.

>RETRV EXIT

[^]/[N-]: Select

[ENTER]:Enter

Choices:

RETRY,

EXIT

• Select “RETRY” to retry the “AUTO SETUP”

procedure.

• Select “EXIT” to exit from the “AUTO SETUP”

procedure.

If “E-5:NOISY” appears, “PROCEED” also appears in the

choices. When you select “PROCEED”, this unit continues the

measurements and settings, but the settings may not be optimal.

UARNING

W-l:0UT OF PHASE

Reverse Channel

—

CENTER

SBL

SBR

[-^]/[N-]:Select

[ENTER]:Return

' For details about each warning message, see the “AUTO

SETUP” section in “Troubleshooting” on page 117.

• When the corresponding warning message is not

applicable to a speaker, “—” is displayed instead.

► If “SWFR: TOO LOUD” or “SWFR: TOO LOW” appears

in the “W-3: LEVEL ERROR” display, adjust the volume

level of the subwoofer(s).

Press (D ENTER to return to the top result
display.