Yamaha RX-V663 - Manual (Page 69)

SIRIUS Satellite Radio tuning
Before performing the following operations, press @) SIRIUS
on the remote control.
Setting the SIRIUS Satellite
Rattle^ preset channels
You can use this feature to store up to 40 SIRIUS Satellite
Radio channels (A1 to E8: 8 preset channel numbers in
each of the 5 preset channel groups). You can then recall
any preset channel easily by selecting the preset channel
group and number as described in “Preset Search mode”
on page 64.
1
Search for a channel you want to set as a
preset channel by using one of the SIRIUS
Satellite Radio search modes.
See “Basic SIRIUS Satellite Radio™ operations” on
page 63 for details.
001. SIRIUS Hit.
T
Currently selected channel number
2 Press ©MEMORY (or® MEMORY).
The MEMORY indicator flashes in the front panel
display for approximately 30 seconds.
MEMORY
Flashes
You must proceed to and carry out steps 3 through 4 while
the MEMORY indicator is flashing in the front panel
display.
Press ©PRESET/TUNING/CH <] /1>
(or ® PRESET/CH
A / V)
repeatedly to select
a preset channel group and number (A1 to
E8) while the MEMORY indicator is flashing.
The preset channel number appears in the front panel
display.
Flashes
You can select the preset station group (A to E) by pressing
© A/B/C/D/E (or ® A-E/CAT, / D>) repeatedly.
Press ©MEMORY (or ©MEMORY) to set
the selected SIRIUS Satellite Radio channei
as a preset channel while the MEMORY
Indicator is hashing.
A colon (:) appears next to the preset channel number
for confirmation, and the MEMORY indicator turns
off in the front panel display.
fl 1^023 Hair N.3
Colon (:)
Note
Once you set a new preset channel, the one previously stored in
the same preset channel group and number is cleared.
Setting the Parental Lock
You can use the Parental Lock feature to limit the access
to the desired SIRIUS Satellite channels. This unit
automatically skips the locked channels when this unit is
in the All Channel Search mode or Category Search mode
and you search a channel by pressing
©PRESET/
TUNING/CH
<1 / O (or ©
PRESET/CH
A / V).
■ Setting the code number and the locked
channels
Use this feature to set the Parental Lock code number
(PIN) and select the channels to be locked.
1 Press ©AMP on the remote control and then
press i^MENU to display.
2 Press
©V
to select “MANUAL SETUP” and
then press ©ENTER.
3 Press
©V
repeatedly to select “INPUT
MENU” and then press ©ENTER.
,fll, 023 Hair- N.3
Currently selected preset channel group and
number
65
En