Yamaha RX-V663 - Manual (Page 101)

Customizing this unit (MANUAL SETUP)
m
Video settings B)UIDE 0 SET
Note
Use “VIDEO” of “INIT’ in “ADVANCED SETUP” to set the
parameters in “VIDEO SET” to the factory presets (see
page 109).
■ Memory guard OMEMORV GUfiRD
Use this feature to prevent accidental changes to sound
field program parameter and other system settings.
OMEMORV GUARD
>0FF ON
B>iJIDE0 SET
IJIDEO CONU..... ON
[A]/[T]: IJp/Down
Select
Video conversion UIDEO COHU.
Use this feature to set whether to convert the video signals
input at the VIDEO, S VIDEO, and COMPONENT
VIDEO jacks.
Chok» FUi№tlOn»
ON Converts composite, S-video, and component
video signals interchangeably and up-converts
composite, S-video, and component video
signals to HDMI video signals.
OFF Does not convert any signals.
Notes
• This unit does not convert 480 line video signals and 576 line
video signals interchangeably.
• The analog component video signals with 480i (NTSC)/576i
(PAL) of resolution are converted into the S-video or composite
video signals and output at the S VIDEO MONITOR OUT and
VIDEO MONITOR OUT jacks.
• The converted video signals are only output at the MONITOR
OUT jacks. When recording a video source, you must make the
same type of video connections between each component.
• When composite video or S-video signals from a VCR are
converted into component video signals, the picture quality may
suffer depending on your VCR.
• Unconventional signals input at the composite video or S-video
jacks cannot be converted or may be output abnormally. In such
cases, set “VIDEO CONV.” to “OFF”.
[^]/[P]; Select
CENTER]: Return
Chotee
. ’ 1
OFF
Turns off the “MEMORY GUARD” feature.
ON Protects:
- sound field program parameters
- “AUTO SETUP” items
- all speaker levels
- “MANUAL SETUP” items
Notes
• You can change the following parameters even if “MEMORY
GUARD” is set to “ON”;
- “EXTD SUR.” in “SOUND MENU” (see page 92)
- “DECODER MODE” in “INPUT MENU” (see page 94)
- “PARENTAL LOCK” in “INPUT MENU” (see page 94)
- “MEMORY GUARD”
• When “MEMORY GUARD” is set to “ON”, “g” appears at the
top right of the “SET MENU” screen.
• You can change the settings of “SUR.” in the sound field
program parameter screen (see page 77) even if “MEMORY
GUARD” is set to “ON”.
97
En