Yamaha RX-V663 - Manual (Page 106)

Remote control features
Setting remote control codes
You can control other components by setting the
appropriate remote control codes. For a complete list of
available remote control codes, refer to “List of remote
control codes” at the end of this manual.
Remote control code default settings
9бфт>}::
............................-.............................
l/liinyfaoliiiw
A TUNER Yamaha 5012
XM TUNER Yamaha 5009
SIRIUS TUNER Yamaha 5017
CD CD Yamaha 5013
MD/CD-R CD-R Yamaha 5001
TUNER TUNER Yamaha 5007
DVD DVD Yamaha 2000
DTV/CBL — — —
V-AUX TUNER Yamaha 5011
DVR DVR Yamaha 2011
В TUNER Yamaha 5009
Note
You may not be able to operate your Yamaha component even if a
Yamaha remote control code is preset as listed above. In this case,
try setting another Yamaha remote control code.
1 While pressing and holding one of the input
seiector buttons (
0
) on the remote control to
select the control area you want to set up,
press ©AV POWER for more than 3
seconds.
®AMP flashes twice.
f~F~l XM SIRIUS
□ CZ) CZD
CO MD/CD-R TUNER
О О О
DVD DTV/CBL DVR
О о Q\
\FAUWDOCK VCR Г~ВПУ^
О О О
While holding down
Press for 3
seconds
f
•>. I AMP I :o:
, -' *<* '' _
flashes
2 Press the numeric buttons (0 to 9) (®) to
enter the four-digit remote control code for
the component to be used.
When the setting succeeds, ©AMP flashes twice;
however, when it does not, ©AMP flashes
repeatedly.
Notes
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you do not press any buttons within 30 seconds in step 2, the
setup process is canceled. If this happens, repeat the setup
procedure.
■ Resetting all remote control codes
Use this feature to clear all the remote control codes
previously set and reset all of them to the initial factory
settings.
1 While pressing and hoiding ©AMP on the
remote control, press ©AV POWER for
more than 3 seconds.
(DAMP flashes twice.
ПШ р П POWER
—
While holding
Press for 3
down
\
'v 1 AlilP
1
. - ;o:
flashes
seconds
Press the numeric buttons (©) to enter the
code number “9981 ”.
When the setting succeeds, ©AMP flashes twice;
however, when it does not, ©AMP flashes
repeatedly.
If you do not press any buttons within 30 seconds after step 1, the
clearing process is canceled. In this case, repeat the clearing
procedure.
102ЕГ7