Yamaha DEQ7 - Manual (Page 14)

Single Program Bulk Dump
Each time a program is recalled using the RECALL key, a bulk
dump of the recalled program is performed via the MIDI OUT ter­
minal. If the transmitted program is between 31 and 90, it will be
stored in the correspondingly numbered location in the receiving
DEQ7.
Bulk Dump Reception
The DEQ7 will automatically receive a bulk dump of program or
bank data when a MIDI BULK DUMP REQUEST signal is received
from the transmitting device.
CONVERT L=R L/R
This function converts L=R programs (programs 1, 4, 7, 13, 16, 18
and 21) stored in the RAM memory to the equivalent L/R types,
thus allowing independent programming of the left and right chan­
nel parameters. It can also be used to convert the Lch GEQ pro­
grams (9 and 11) to the corresponding Rch types, and the Rch GEQ
programs (10 and 12) to the corresponding Lch types.
® Select the program stored in the RAM memory area which is to
be converted.
DELAY DISPLAY
The DEQ7 offers you a choice of delay display (the L DELAY and
R DELAY parameters called by the DELAY/LEVEL key) in sec­
onds, meters or feet. The METER and FEET display options are a
handy guide when the DEQ7 delays are used to compensate for
physical distances between speaker systems in large sound installa­
tions.
® Press the UTILITY key a few times until the DELAY DISPLAY
function appears.
® Use the parameter editing
A
and
V
keys to select the SEC­
OND, METER or FEET display option.
Hold the UTILITY key down until the UTILITY mode is exited.
D E L A Y D I S P L A Y
U N I T = S E C O N D
I FKRAM-
ET£R
I f
D E L A Y D I S P L A Y
U N I T = F E E T
* Press the UTILITY key a few times until the CONVERT func­
tion ajjpears.
Press the program selection A key to perform the conversion.
Hold the UTILITY key down until the UTILITY mode is exited.
Selected
program
3S P E Q ( 4 + 4 ) L = R
P E A K 1 2 2 5 H z
UTILITY
i®/
r ' - J
C O N V E R T ?
L = R — > L / R
Display corresponds
to the type of
program selected.
*If a program which is NOT of the L=R, Lch or Rch type is
selected, the CONVERT function will be skipped.
12