Panasonic KX-P7510 - Manual (Page 41)

Using the Printer
The following explains some menu items displayed on the operator panel.
For detailed information, refer to Operating Instructions in the KX-P7500 Series CD-
ROM.
Menu
CONFIG
MENU
JOB
MENU
Item
PWR SAVE
JAM RECV
MENU CLR
FUSER
CLEAN
Values and Functions
OFF
15 (Factory Default)
30
45
60
The PWR SAVE {Power Save) menu item lets you reduce
power usage when the printer is idle. The PWR SAVE
setting determines the length of time (in minutes) the
printer waits after the last print job is received or pressing
any button on the operator panel before it automatically
goes to a reduced power state. Full power mode is
restored when the printer receives a job or when you press
any button on the operator panel. To conserve energy and
operating cost, this printer is provided with a
programmable power save (PWR SAVE) feature. The
printer is factory set with the power save feature turned on
and programmed to 15 minutes to comply with E
nergy
S tar ® requirements.
OFF (Factory Default)
ON
When JAM RECV (Jam Recovery) is set to ON, the printer
keeps printed page until the printer signals that the page
has successfully exited the printer. The printer reprints the
jammed page.
When JAM RECV is set to OFF, the printer does not reprint
a page that has been jammed after all the image has been
drawn on the page.
When you select MENU CLR (Menu Clear), the printer
resets to the factory default setting for each menu item.
If there happens random dirty spots on the back side of
paper, select FUSER CLEAN. It cleans fuser
contamination.
FUSER CLEAN selection rotates the motor about 10
seconds and prints one page duplex printing pattern for
fuser clean.
41
B
c
w
5‘
(O
a
o
■o
o
0)
■D
0)
3
(D