For users in u.k – Panasonic KX-P7510 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

FOR USERS IN U.K.

IMPORTANT:

FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY

This printer is supplied with a moulded three pin mains plug each for your safety and
convenience.

A 13 amp fuse is fitted in this plug. Should the fuse need to be replaced please ensure that
the replacement fuse has a rating of 13 amps and that it is approved by ASTA or BSI to BS

1362.

Check for the ASTA mark

or the BSI mark VC ^ on the body of the fuse.

If the plug contains a removable fuse cover you must ensure that it is refitted when the fuse

is replaced. If you lose the fuse cover the plug must not be used until a replacement cover is

obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer.

IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN

YOUR HOME THEN THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF AND

DISPOSED OF SAFELY. THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF

THE CUT OFF PLUG IS INSERTED INTO ANY 13 AMP SOCKET.

If a new plug is to be fitted please observe the wiring code as shown below.
If in any doubt please consult a qualified electrician.

WARNING: THIS APPLIANCE MUST BE EARTHED.

IMPORTANT: The wires in this mains lead are coloured in accordance with the following

code.

Green-and-Yellow: Earth Blue: Neutral Brown: Live

As the colours of the wire in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows.

The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the
plug which is marked with the letter E or by the Earth symbol , or coloured GREEN or
GREEN-AND-YELLOW.

The wire which is coloured BLUE must be connected to the terminal in the plug which is

marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the terminal in the plug which is
marked with the letter L or coloured RED.

How to replace the fuse: Open the fuse compartment with a screwdriver and replace the

fuse.

SCREWDRIVER

FUSE COVER