Panasonic KX-P 1131 - Manual (Page 34)

Using the Control Panel
Interface Setup Mode
The following items can be set in the Interface Setup mode through the Control Panel: INTERFACE, DATA
LENGTH, BAUD RATE. PARITY, PROTOCOL and SIGNAL POLARITY.
You can select and change the desired item according to the status of the FONT/PITCH indicators.
“I Load a sheet of paper (ns* P. 13-16), and turn
the power off.
While pressing [ PITCH 1, turn the power on
to enter the Interface Setup mode.
Both FONT indicators and the HIGH SPEED
indicator will be blinking.
The current settings will be printed
automatically.
Press and release [ FONT) to select the
item.
Each time you press (FONT], you will
advance to the next item. Select the desired item
according to the status of the FONT indicators
(on, off, blinking).
Press and release
f
PITCH ] to set the item’s
status.
The item’s status will change each time you
press
f
PITCH ]. See the table below to verify
desired status.
To change additional settings, repeat steps 3
and 4.
Item Setting
FONT
Indicators
(Press
[FONT])
PITCH indicators (Press f PITCH ] )
o o 0 • • O • • 0 • • o • •
INTERFACE o • AUTO PARALLEL SERIAL — — — —
DATA LENGTH • o 8 bit 7 bit — — — —
—
BAUD RATE • • 300 600 1,200 2,400 4,800 9,600 19,200
PARITY o •' NONE IGNORE ODD EVEN — — —
PROTOCOL • o DTR
XON/
XOFF
— — — — —
SIGNAL
POLARITY
• • MARK SPACE — — —
—
—
FONT/PITCH indicators condition:
• =!ight is lit 0=:light is out ►=light is blinking
Press [ LOAD/PARK ] to exit the Interface
Setup mode.
FONT indicators will go off and the current
conditions will print.
Note:
• To return all current settings to the factory
settings, follow the steps below.
1. While pressingf LOAD/PARK], turn the
power on, then release.
2. Press [ TEAR OFF ],
3. Press ( LOAD/PARi^ to exit the Initial Setup
mode.
34