Using the control panel, Selecting a character font, Press and release! font – Panasonic KX-P 1131 User Manual
Page 28: Selecting a character pitch, Press and release (pitch, Font, Pitch
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the Control Panel
Selecting a Character Font
This printer contains resident fonts which are accessible through the Control Panel.
You can select any one of the character fonts by pressing the FONT switch on the Control Panel.
• Press and release!
FONT],
The combination of FONT indicators indicates the
current character font selected, as shown on the
Control Panel.
(0)1 FONT I = PROGRAM
cT~• I FONT j = Roman
»
zd
[
font
| = P r e s t i g e
= Sans Serif
cr# |
font
| = ScMp^
3
>
[
font
I
= Courier
•=light is lit
FONT
o=Nght is out •=light is blinking
Note:
You must be in PROGRAM (both FONT indicators are off) to allow your software to control your font selection.
Selecting a Character Pitch
This printer contains resident pitches which are accessible through the control panel.
You can select any one of the character pitches by pressing the PITCH switch on the control panel.
Press and release (
PITCH].
The combination of PITCH indicators indicates the
current character pitch selected, as shown on the
Control Panel.
cns
PITCH
= PROGRAM
PITCH
PITCH
— 10 CPI
•3*
PfTCH
»ZD PITCH = 17 CPI
•flight is lit
o=light is out •=light is blinking
I Note:
I • You must be in PROGRAM (both PITCH indicators are off) to allow your software to control your pitch
! selection.
28