CANOGA PERKINS N525 Ethernet Termination Service Unit User Manual
Page 82
4-6
N525 Ethernet Termination Service Unit
e. DF Bit
Sets if the network can fragment Test Packets. Set allows fragmentation,
Clear does not allow fragmentation
f. DSCP Precedent
Sets IP Packet priority. Options are: Best Effort, Class 1, Class 2, Class
3, Class 4, Internet Control, Network Control, Not Used. Pressing
Drop Probability
Sets IP packet Discard Priority. Options are Low, Medium, High, not used
g. Test Packet Priority
Sets VLAN frame priority. 0 to 7
h. Test Duration min:sec
Test duration in minutes and seconds, 0 for a continuous test
i. Min Test Packet Size
Sets minimum packet size. 40 to 1472 bytes
j. Max Test Packet Size
Sets maximum packet size. Must be equal to or greater than the Minimum
Packet Size. The N525 increments packet size from the minimum to the
maximum when the next packet is sent during a test. When the maximum
size has been sent, the size is reset to the minimum size and the
incrementing continues. Maximum packet size is from 40 to 1472 bytes.
k. Test Packet Timeout
How long to wait for a test packet to return
l. Start/Stop Test
Starts the test or stops the test prior to automatic completion or when in
Continuous (Duration setting of 0).
m. Remote Latency Test
Initiates and configures Latency and Jitter testing on a Remote N525
when SBMC is enables.
3. When the Latency/Jitter test is finished running, press
Menu.