CANOGA PERKINS N525 Ethernet Termination Service Unit - Manual (Page 25)

N525 Ethernet Termination Service Unit 3-7
System Configuration
View and set values for the system information and communications parameters.
1. IP/SNMP Agent Configuration
The Management IP and Auxiliary IP Address are for managing and conducting
performance testing on a TCP/IP network. Enter the Management IP Address
in this field.
2. Trap Configuration
This defines the handling of various alarm events. You can log and/or send the
event, as well as ignore it. For CLD traps, see
Configuring CLD .
3. Security Configuration
This configures user and SNMP security for the N525.
4. Account Information
This managed user access to the N525 including privileges, passwords and
access methods.
5. System Information
This allows the addition of administrative information about the N525 and circuit
information such as the N525’s name, contact, location, customer, circuit,
equipment codes and CLIE information.
6. Radius Client Information
This configures the N525 for RADIUS Authentication of user. The N525
implements Radius Passthru for user authentication by a RADIUS Server.
7. SNTP Client Configuration
This configures the N525 to use a primary and secondary SNTP Server for
setting date and time.
8. SYSLOG Client Configuration
This configures the N525 to send SYSLOG messages to a SYSLOG Server for
collections and dissemination.
9. Hardware Information
This displays information about the N525 including full model numbers of the
N525 and its Interface modules, hardware revision levels and serial numbers.
When the N525 is connected to a remote N525, L351 or L357 and SideBand
Management Channel is enabled, information about the remote device is also
displayed.