CANOGA PERKINS N525 Ethernet Termination Service Unit - Manual (Page 37)

N525 Ethernet Termination Service Unit 3-19
2. At the System Information screen, type the number for an item and press , then
type the information and press .
a. System Name – Displayed in the header of all N525 Management screens, up to
25 characters
b. Contact – up to 25 characters
c. Location – up to 25 characters
d. Customer – up to 25 characters
e. Information – 2 lines, up to 40 characters each
f. Circuits – 2 lines, up to 25 characters each
g. Service Code – up to 10 characters
h. Date-in-Service – [mm/dd/yyyy]
i. Date-Out-of-Service – [mm/dd/yyyy]
j. Equipment Type – up to 10 characters
k. Equipment Code – up to 10 characters
l. Vendor – up to 25 characters
m. CLEI – up to 10 characters
n. Mfg Date – [mm/dd/yyyy]
o. Unit – Displays System Information for a SMBC connected remote N525
3. To change the view between Local and Remote units, type [ 15 ], "Unit," press .
Pressing cycles between the options. Press to select an option.
4. To return to the Main Menu, press .
View Device and Module Information
The Hardware Information report shows hardware descriptions, including the type, model, serial,
and revision numbers for the N525 and Interface Modules, as well as the power supply status.
You can also view similar information for the remote unit. Exact parameters depend on the
specific remote unit. Use this information when troubleshooting, such as tracking down an error
in a data link or the configuration. To view the Hardware Information screen, follow these steps:
1. From the Main Menu, type [ 3 ], "Port Information," and press . Then from the Port
Information Menu, type [ 2 ], "Port Configuration," and press . Type [ 1 ], "Hardware
Information," and press .