CANOGA PERKINS N525 Ethernet Termination Service Unit - Manual (Page 20)

3-2 N525 Ethernet Termination Service Unit
4. At the COM Properties dialog, on the Port Settings tab, check for these
selections:
• Bits per second: 19200 bps
• Data bits: 8
• Parity:
None
• Stop bits: 1
• Flow control: None
5. Click OK. HyperTerminal connects to the system and the VT100 terminal
emulation starts.
6. Select the Properties button on the Hyperterminal window tool bar, click on the
settings tab, and change emulation from Auto Detect to VT100.
Setting Up SNMP Network Management
Typically, the N525 communicates with CanogaView or your network management
platform in-band using the transported Ethernet network.
Network Management Platform Setup
Industry standard Management Information Bases (MIBs) are required on your network
management platform in order to successfully communication with the N525 using
SNMP. Before you start, check that these industry-standard MIBs are loaded:
1. Standard MIB
2. Dot2sd.mib
3. Etherlike.mib
4. If.mib
5. Bridge.mib
6. Pbridge.mib
Additionally, Canoga Perkins Private MIBs are need on the network management
platform. The Canoga Perkins Private MIBs are available on Canoga Perkins website,
www.canoga.com . The MIBs are located in a password protected area of the website. If
you do not yet have a Canoga Perkins username and password, please contact Tech
Support.
1. Cp.mib: Supports all Canoga Perkins products
2. Cpsysinf.mib: Supports SNMP access
3. Cphost.mib: Supports Host Table and Host Access functions
4. Cptraptb.mib: Supports the Trap Table