Vernier LabPro - Manual (Page 84)

Revision Date: 08/02/02
LabPro Technical Manual C-1
Appendix C: DataMate Sensor Setup Default Settings
The table that follows shows the default settings used by the DataMate program. This sensor and
calibration information applies only to Vernier and TI sensors. The use of other manufacturers’ sensors
may require calibration or the input of that sensor’s calibration information into DataMate.
Note: Default settings apply only when using a single sensor that is connected to Channel 1.
Sensor Name Short Name Y-Min Y-Max Sample Interval
(in seconds)
No. Of
Samples
Dir connect Temp
(C)
TEMP(C) -15 110 1 180
Dir connect Temp
(F)
TEMP(F) 0 250 1 180
Extra Long Temp
(C)
TEMP(C) -50 150 1 180
Stainless Temp (C) TEMP(C) -20 125 1 180
Stainless Temp (F) TEMP(F) -5 260 1 180
Thermocouple (C) TEMP(C) -200 1400 1 180
pH PH 0 14 2 60
Conduct 200 (
µ
S) CONDUC
T
(MICS) 0 200 1 180
Conduct 100(MG/L) TDS(MG/
L) 0 100 1 180
Conduct 2000(
µ
S) CONDUC
T
(MICS) 0 2000 1 180
Conduct
1000(MG/L)
TDS(MG/
L) 0 1000 1 180
Conduct 20000(
µ
S) CONDUC
T
(MICS) 0 20000 1 180
Conduct
10000(MG/L)
TDS(MG/
L) 0 10000 1 180
Gas Pressure (KPA) PRESS
(KPA) 50 150 10 90
Gas Pressure
(MMHG)
PRESS
(MMHG) 400 1200 10 90
Gas Pressure
(ATM)
PRESS
(ATM) 0.5 1.6 10 90
Gas Pressure
(INHG)
PRESS
(INHG) 0 65 10 90