Vernier LabPro User Manual

Page 46

Revision Date: 08/02/02

LabPro Technical Manual

In a terminal session, the host-LabPro conversation appears as follows:
Host

LabPro

s{0}
s{7}

{ +6.01120E+00, +0.00000E+00, +0.00000E+00, +8.88800E+03,
+0.00000E+00, +0.00000E+00, +0.00000E+00, +0.00000E+00, +0.00000E+00,
+0.00000E+00, +0.00000E+00, +0.00000E+00, +0.00000E+00, +1.00000E+00,
+0.00000E+00, +0.00000E+00, +0.00000E+00}

s{4,2,5,0,1}
s{7}

s{3,10,61,0,0,0,0,0,2}
s{7}

{ +6.01120E+00, +3.10000E+01, +0.00000E+00, +8.88800E+03,
+1.00000E+01, +0.00000E+00, +0.00000E+00, +0.00000E+00, +0.00000E+00,
+6.10000E+01, +2.00000E+00, +0.00000E+00, +0.00000E+00, +1.00000E+00,
+0.00000E+00, +0.00000E+00, +0.00000E+00}

After the Command 3 was issued, the computer indicated an error by beeping 3 times. Command 7 is used
to see the error value, in this case, error 31. Looking the Error code appendix, error 31 means that
Command 3 was sent prior to performing any channel setups. However, the command was accepted and
LabPro can collect data every 10 seconds for 600 seconds and apply a Savitzsky-Golay 9-point filter.