Vernier LabPro - Manual (Page 28)

Revision Date: 08/02/02
LabPro Technical Manual 28
LabPro Command Summary
The table below lists the commands you can use in writing programs for LabPro.
Command
Number Command Description
0 Reset: Resets all channels to default conditions.
1 Channel Setup: sets up a channel for data collection.
3 Data Collection Setup: Sets up the collection parameters for an
experiment.
4 Conversion Equation Setup (Analog): Sets up parameters to
convert physical units measured by LabPro into a more useful
measurement unit such as newtons or
°
C.
5 Data Control: Selects the type and range of data to be retrieved.
6 System Setup: Turns sound on or off; sets an ID number for
LabPro; selects a filter to be applied to data.
7 Request System Status: Generates and prepares to return status
information.
8 Request Channel Status: Generates and prepares to return
sensor type, last valid data, and last valid data position for the
requested channel.
9 Request Channel Data: Generates and prepares to return one
data point before sampling starts. Used to verify that setup is
correct.
10 Advanced Data Reduction: Sets up LabPro to process certain
time-intensive algorithms instead of processing them in the
calculator.
12 Digital Data Capture: Sets up the capture or measurement of data
from the digital input channel.
102 Port Power Control Command: Sets the power to always on;
power-saving; or designated power up.
105 Baud Rate Selection: Sets
106 Motion Detector Undersample Rate: Sets
107 Oversampling Burst: Sets
115 Request Set-up Information: Returns status information for the
designated channel.
116 Request Long Sensor Name: Returns long sensor name.
117 Request Short Sensor Name: Returns short sensor name.
119 Request Alternate Calibration: Selects an alternate calibration for
the smart sensor.