Waterworks Maritime Traditional Single Fabricated Stone Washstand with Shelf 32" x 23 x 44 1/4" - Manual

Installation Guidelines
W A T E R W O R K S
Waterworks is a registered trademark of Waterworks Inc. 01.03.07
Waterworks Washstand
These guidelines have been prepared for the professional contractor to aid in the installation of:
MODERN WASHSTAND (WWSLAB500 & WWSLAB501) and TRADITIONAL
WASHSTAND (WWSLAB505 & WWSLAB506) all dimensions are based on original specification
and are subject to change and variation. Please consult your Design Associate for current specifications.
IMPORTANT
To ensure this product is installed properly, you must
read and follow these guidelines.
The owner/user of this product must keep this
information for future reference.
Blocking to properly secure the washstand is mandatory.
The slab top is natural stone that has not been sealed.
Oil based products, including plumbers putty must
never be used under any circumstances on natural
stone.
Modern Carrara Washstand
WWSLAB500
36"
23"
35"
23"
32"
44 1
4
"
34"
10 1
4
"
Modern Danby Washstand
WWSLAB501
44 1
4
"
34"
10 1
4
"
6"
23"
6"
23"
Be sure your installation conforms to applicable codes.
Inspect this product to assure you have all parts
required for proper installation. The assembly is
supplied with a brass slab support and adjoining bolts.
ROUGH IN:
1. REQUIRED: a 2x6 on its side for blocking in the wall
is mandatory to adequately secure the washstand and
top. Width of blocking should be a minimum of 32"
wide and centered 33" above the surface of the
finished floor.
SLAB AND LEG INSTALLATION:
2. Position the left leg in the proper location and make a
mark where the leg pin contacts the floor. Drill a 3/8"
diameter hole in the floor for the pin to rest in.
3. Attach the slab support between the 2 legs using the
hardware provided.
4. Reposition the washstand legs and slab support to the
proper location and make a mark where the pin on
the right leg contacts the floor. Drill a 3/8" diameter
hole in the floor for the pin to rest in. It is
recommended that the legs are secured to the floor
using water based silicone.
5. Verify that the washstand components are level and
plumb then secure the slab support to the wall using
the 4 screws provided.
6. Apply water based silicone to the top of each leg and
the slab support. Place the slab down onto the legs
and slab support and wipe away any excess silicone.
BACKSPLASH/SHELF INSTALLATION .
7. After the silicone securing the top has cured, silicone
the backsplash to the wall and top and apply a bead
of silicone where the shelf meets the wall.
If further assistance is required, please contact Product
Support at 1-800-927-2120 (8am-7pm EST).
Traditional Carrara Washstand
WWSLAB505
Traditional Danby Washstand
WWSLAB506
Carrara without Backsplash
WWSLAB500WOB
Danby without Backsplash
WWSLAB501WOB
Carrara without Backsplash
WWSLAB505WOB
Danby without Backsplash
WWSLAB506WOB