Waterworks Universal Three Way Diverter Valve without Shutoff for Pressure Balance Shower Systems - Manual (Page 2)

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
UNIVERSAL
Three Way Diverter Valve For Pressure Balance Shower Systems Installation Guidelines
Page 2 of 2
Rev - 05
6.16.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
UNIVERSAL THREE WAY DIVERTER VALVE FOR PRESSURE BALANCE SHOWER SYSTEMS
STYLE No. GUDV65, GU65DV (UK).
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
¾ You must have the pressure balance valve (GUPB81 or
GUPB87) on hand in order to install the diverter valve
(GUDV65).
1. Make sure the valve is positioned according to the
valve markings with the inlet port situated so that
mixed water flows into the inlet.
2. Rough-in the diverter valve to an appropriate depth
based on the trim being used.
3. The cartridge stem and threaded tube on the diverter
valve can be cut to various lengths depending on the
style of trim.
¾ Refer to the Installation Guidelines of individual trims
for cutting dimensions and related information.
4. After the rough-in is completed, turn on the hot and
cold supplies and check for leaks. Allow the water to
run so the lines can be flushed completely.
5. Verify all the valves are functioning properly.
MIXED WATER INLET
CARTRIDGE STEM
THREADED TUBE
6. Attach the stem extension to the cartridge stem with
the screw then install the tile guard.
¾ If further assistance is required, please contact Product
Support at 1-800-927-2120 (8am-6pm EST).
¾ See the service part document for parts ordering,
available on WATERWORKS.COM.
† BSP Adapter can be ordered separately:
(4x) STYLE No. UNUK02
ITEM No. 45-57632-24328
STEM EXTENSION
SCREW
TILE GUARD