Waterworks Julia High Profile Concealed Tub Filler with Metal Handshower and White Porcelain Lever Handles - Manual

Julia Concealed Deck Mounted Tub Filler With Handshower
JUTU19 (cross handles and metal handshower)
JUTU20 (metal lever handles and handshower)
JUTU21 (white porcelain lever handles and handshower)
JUTU23 (black porcelain lever handles and handshower-MTO)
7 3
4
"
4" MIN.
2 1
2
"Ø
3 1
2
"
3 1
4
"
3 5
8
"
3 1
4
"
JUTU20 JUTU21, 23
2 1
2
"Ø
9"
3 3
8
"
5 1
4
"
4" MIN. 9 1
4
"
3 1
4
"
2 1
2
"Ø
These guidelines have been prepared for the professional contractor to aid in the installation of:
JULIA CONCEALED DECK MOUNTED TUB FILLER WITH HANDSHOWER, CROSS
HANDLES (JUTU19) & LEVER HANDLES (JUTU20, JUTU21, JUTU23) All dimensions are
based on original specification and are subject to change and variation. Please consult your Design Associate
for current specifications.
When you screw the escutcheon onto the deck valve
body, expose several threads above it. Next, screw valve
cover down until it seats. Then move the escutcheon up
until it loosely meets the bottom of the cover. Finally,
tighten bottom lock nut to secure valve to deck.
Once the spout is securely mounted, install the flexible
hoses between the spout and valve bodies using the
gaskets provided.
Connect the handshower hose to the anti-scald
protection device located at the base of the spout's tee.
NOTE: The anti-scald protection device will stop the flow
of water exceeding a temperature of 115 degrees
Fahrenheit.
After installation, unscrew and remove the aerator
assembly. Carefully open the hot and cold valves fully to
flush out any debris in the supply lines. Once the lines
have been flushed, close the valves and reinstall the
aerator assembly.
IMPORTANT: It is necessary to check for leaks and
proper function of mixer prior to being enclosed.
If further assistance is required, please contact Product
Support at 1-800-927-2120 (8am - 7pm EST).
Use only a protected, smooth-jawed, or strap wrench on
any finished surface.
For proper installation, the deck surface should be
installed prior to mounting the mixer.
It is recommended that an access panel be provided for
future service.
Check the specification (left) for drilling holes sizes and
suggested centers.
Run 3/4" supply lines for maximum water flow.
Accessible shut-off valves, which will facilitate servicing, are
recommended for the hot and cold feed lines.
To remove trim from the valve body, pull out index
assembly (held in place by friction o-ring), exposing the
screw for the handle. The cover and escutcheon should
be hand tight.
DO NOT use putty on deck fittings. Upper and lower
washes are provided.
Installation Guidelines
W A T E R W O R K S
Waterworks is a registered trademark of Waterworks Inc. 01.24.08