Waterworks Formwork Pressure Balance with Diverter Trim with Metal Lever Handle - Manual (Page 2)

PRODUCT SUPPORT 800.927.2120 8am - 6pm EST
FORMWORK
Pressure Balance with Diverter Trim with Metal Lever Handle Installation Guidelines
Page 2 of 3
Rev - 01
4.30.2014
These guidelines have been prepared for the professional contractor to aid in the installation of:
FORMWORK PRESSURE BALANCE WITH DIVERTER TRIM WITH METAL LEVER HANDLE (STYLE No. FMPB30)
All dimensions are based on original specification and are subject to change and variation.
Please consult your Design Associate for current specifications.
FIGURE - 02
3. Allow the VALVE to run in the warm position for a few
minutes to completely flush the system. If the system
is significantly dirty, remove the VALVE SPINDLE to
ensure proper flushing as shown in Figure - 03.
¾ Refer to the installation guidelines for the valve which
contains a complete parts breakdown and related
information.
FIGURE - 03
HOT LIMIT SAFETY STOP CALIBRATION:
¾ IMPORTANT: The VALVE is equipped with a HOT
LIMIT SAFETY STOP SCREW to limit the VALVE
SPINDLE from being turned to excessive hot water
discharge temperatures.
PACKING
NUT
VALVE
VALVE STEM
HANDLE
PACKING
NUT
VALVE
VALVE STEM
HANDLE
VALVE
FINISHED
WALL
VALVE
SPINDLE
PLASTIC
WASHER
BONNET
VALVE
FINISHED
WALL
VALVE
SPINDLE
PLASTIC
WASHER
BONNET
4. Turn the VALVE STEM to open the VALVE to the
maximum desired temperature. Verify the temperature
with a thermometer and turn the HOT LIMIT SAFETY
STOP SCREW clockwise until it seats as shown in
Figure - 04.
¾ WARNING: Failure to adjust the HOT LIMIT SAFETY
STOP SCREW properly may result in serious scalding.
FIGURE - 04
TRIM INSTALLATION:
5. Thread the GLAND COVER onto the PACKING NUT as
shown in Figure - 05.
FIGURE - 05
HOT LIMIT SAFETY
STOP SCREW
FINISHED
WALL
VALVE
VALVE STEM
HOT LIMIT SAFETY
STOP SCREW
FINISHED
WALL
VALVE
VALVE STEM
FINISHED
WALL
PACKING
NUT
GLAND
COVER
FINISHED
WALL
PACKING
NUT
GLAND
COVER